Universal,liquid contact adhesive based on neoprene rubber.
Ideally suited for surface bonding o laminating of many materials that require immediate loading o processing. Bonds instantly and super strong. suitable materials under tension
Application:
Bonds wood, board, veneer, plastic and metal panel boards (HPL, Formica®, for example), (foam) rubber, leather, cork, canvas, linoleum and polyether foam (sound insulation), among other things, to itself as well as to many other surfaces. Also for repairing shoes, bags, toys, and carpets, or for doing (hobby) handicraft work. Not suitable for polystyrene foam (Tempex®), PE, PP, and vinyl.
Working conditions :
Use adhesive and parts to be bonded at room temperature only. The relative humidity must be below 65%. This is to avoid the formation of bubbles in the final product. Once attached, adjustment is no longer possible. Always test on an (inconspicuous) part of the surface first.
Surface requirements :
The following are the requirements that we have to use before using the Bison Kit Contact Adhesive.
Surfaces must be dry, clean, dust- and grease-free, and a good fit. Clean and degrease the surfaces to be bonded for optimal results.
Preliminary surface treatment
For optimal results, de-grease first.
Tools
Use a solid brush or fine-toothed (1 mm) glue spreader to cover large surfaces. Use a roller or rubber mallet to join the materials firmly.
Preparation of product
How to Prepare the Kit for Bison Kit Contact Adhesive.
Stir well before use. Should preferably not be diluted.
DURING USE:
Directions for use
Parts must be clean, dry, and free of grease. Coat both substrates completely. Allow drying for a minimum of 10-40 minutes. In the case of porous materials, apply a second coat, and let dry. Then join parts and roll or tap firmly (with a rubber mallet).
Points of attention
For optimum results, both the adhesive and the parts to be bonded must be at room temperature (definitely do not use below +10°C). The final bonding strength depends on the pressure applied. Therefore, press as firmly as possible across the entire surface. Should the adhesive joint between porous materials be exposed to long-lasting contact with water, the adhesive may detach from the wet surface.
AFTER USE:
Stains/residue :
Remove wet adhesive residue immediately with Degreaser/Thinner for Bison Kit®. Dried excess adhesive can only be removed mechanically or with a paint stripper (pre-test).
Storage conditions
Store properly closed in a cool and frost-free place. Shelf life is a minimum 24 months.
